Pool Cage Rescreening in Bartow, FL
ABC Pool Cage Painting rescreens pool enclosures and lanais for Bartow homeowners, replacing torn or sun-worn screen with materials suited to Central Florida heat and storms.
- Free Written Estimate
- Fast Scheduling
- Built for Florida Weather
- Licensed & Insured
- Free Written Estimates
Request Your Free Estimate
Request a free rescreening estimate for your Bartow pool cage.
- Free No-Obligation Estimate
- Fast Response Times
- No Pressure Consultation

Bartow’s older neighborhoods near downtown and the newer construction off Highway 98 share the same humid subtropical climate, and that shows in pool cages. Daily UV exposure breaks down screen fibers over time, and summer storms rolling through Polk County put wind pressure on panels that have already gone brittle, leading to tears, pulled spline, and sagging corners.
ABC Pool Cage Painting sends crews into Bartow from the surrounding Polk County area to rescreen enclosures panel by panel, matching mesh type and frame condition to how the lanai is actually used. The result is a cage that holds screen tension properly and resists the next round of afternoon thunderstorms.
Bartow’s Climate and Older Screen Enclosures

Bartow sits inland in Polk County, away from coastal salt but not away from heat. Summer afternoons regularly push into the mid-90s with high humidity, and that combination of UV and moisture is what ages screen from the inside out. By the time a homeowner notices a tear, the mesh around it has usually already gone stiff and brittle.
Homes in older sections near downtown Bartow, with enclosures original to the house, tend to show screen failure at the spline track first. Newer construction off Highway 98 or toward Lakeland Highlands often has cages holding up better structurally, but the screen itself still ages on the same timeline regardless of the frame’s condition.
Afternoon thunderstorms common to this part of Central Florida add wind load to panels that UV has already weakened. A screen that looks intact in June can pull loose from its spline by September. Rescreening before that happens costs less than replacing a frame bent from the inside out.
How We Rescreen a Lanai, Panel by Panel

Rescreening starts with removing the old screen and spline from each panel and inspecting the aluminum frame underneath for bends, corrosion, or loose fasteners. Problems found here get addressed before any new mesh goes in, since screen installed over a compromised frame won’t hold tension properly or last as long as it should.
Mesh selection depends on the household. Standard fiberglass screen suits most lanais, while pet-resistant or no-see-um mesh fits specific needs around pools near wooded lots common in parts of Bartow. Each panel is cut to size, fitted into the track, and secured with new spline rolled in at consistent tension so the screen sits flat without sagging or rippling.
- Old screen and spline removed panel by panel
- Frame checked for bends, rust, and loose screws
- Mesh chosen for sun, pets, or insect concerns
- New spline rolled in for even, lasting tension
Timeline, Access, and Working Around Your Schedule

A standard lanai rescreening in Bartow typically runs one to three days depending on panel count and whether frame repair is needed. Most homes, from older ranch houses near downtown to newer construction off Highway 60 toward Lakeland Highlands, fall into that range. Crews work panel by panel, so the pool itself stays usable most of the time, though we ask that pets and kids stay clear of the work area.
Several Bartow neighborhoods and communities along the Mulberry and Auburndale corridors have architectural guidelines covering screen color and mesh type. If your HOA requires approval before rescreening, we can provide spec sheets for the mesh and hardware ahead of time so you are not waiting on us to submit paperwork. Afternoon thunderstorms common to Central Florida summers can push a job back a day, and we plan around that rather than rushing panels in the rain.
- Pool and patio remain accessible during most of the project
- Debris and old screen material are bagged and hauled off daily
- Work pauses during lightning or heavy rain for safety
Mistakes That Shorten a Rescreen Job

The most common shortcut we see on older Bartow enclosures is installing new screen over a frame that is already loose, bowed, or corroded at the joints. New mesh pulled tight against a weak frame will tear again within a season or two, often at the same corners. Fastener problems are just as easy to miss until a panel starts rattling in the wind.
Mismatched mesh is another frequent issue, especially when only part of a cage is rescreened over time. Pool enclosures often use a tighter weave than patio-only sections, and mixing the two unevenly affects both appearance and how much debris gets through. We match mesh type panel for panel and address frame issues before any new screen goes in, which is what makes the rescreening hold up through Polk County’s storm season rather than needing redone the following year.
Process and Timeline
- Initial walk-through to assess frame condition, mesh type, and panel count
- Written estimate provided with no obligation
- Frame repairs, including re-securing or replacing damaged sections, completed before rescreening begins
- Old screen and spline removed panel by panel and surfaces cleaned
- New mesh installed and trimmed to match existing or HOA-approved specifications
- Final walk-through to check tension, fasteners, and overall fit
Most Bartow rescreening projects are completed in one to three days, depending on cage size and the extent of any frame repair needed.
Bartow Pool Cage Rescreening FAQ
How long does pool cage rescreening take for a typical Bartow home?
Most single-panel-height lanais are rescreened in one to two days, depending on the size of the enclosure and how many panels need new spline as well as screen. A two-story cage or one with pet screen on lower panels can run two to three days.
What screen material holds up best to Central Florida sun and storms?
Standard charcoal or gray fiberglass screen is the common choice and resists UV breakdown well for the price point, while pet-resistant vinyl-coated polyester screen costs more but holds up to claws and debris from summer storms. For homes near open fields or pastureland around Bartow, a heavier no-see-um mesh is sometimes worth the tradeoff in airflow.
Can you rescreen just a few damaged panels instead of the whole cage?
Yes, spot rescreening of individual panels is common and avoids replacing screen that still has useful life left. The tradeoff is a visible difference in haze and color between new and existing screen, which fades over a season or two.
Will rescreening fix a sagging or bowed pool cage frame?
No, rescreening replaces the screen and spline but does not correct bent or spreading aluminum framing. If panels are bowing or a horizontal support has pulled loose, that structural repair needs to happen before new screen goes in, or the new material will stretch and fail early.
Do I need to check with my HOA before rescreening in a Bartow community?
Many Bartow neighborhoods and the surrounding Polk County communities have architectural guidelines covering screen color, frame finish, and sometimes mesh type, so it is worth checking your association's rules before work starts. We can match existing frame color and standard screen shades to keep the enclosure consistent with HOA expectations.
How soon can I use my pool area after the screen is replaced?
The enclosure is fully usable as soon as the crew finishes and cleans up, typically the same day each section is completed. There is no cure time to wait out the way there is with painting.
Nearby Areas We Also Serve
Crews working in Bartow also cover surrounding Polk County communities and the Central Florida towns nearby. Davenport, Mulberry, Lakeland, Winter Haven, Bradenton and Tampa.
Statewide details, colors and the full process are on our main pool cage rescreening page.
Recent Work









Request a Bartow Estimate
Send a few photos of the pool cage along with the property address in Bartow, and we will follow up with a written estimate based on the panel count, screen type, and any frame issues visible in the photos. There is no cost or obligation for this estimate.
Last reviewed: November 1, 2026